comed hosting capacity map

Fax 905-686-1078 The IREC paper advises utilities to be pro-active in ensuring the accuracy of the mapsto save time for utility customers siting and designing new solar installations, and also for utility engineers performing interconnection studies. As outlined in an earlier pv magazine USA article, these still-young hosting capacity maps havent always shown the most accurate information, meaning that solar developers might not have reached out to customers in these regions. This is necessary, because developer complaints have continued to the present. 2. Integrating hosting capacity analysis with the interconnection process is not only possible, it is already being done. Peak and Minimum Load Duration Curves www.tdworld.com is using a security service for protection against online attacks. Subject to your specific situation, ComEd's response may require further action to be taken and/or further expense to be incurred by you in order to complete the interconnection. Utility National Grid operates in Rhode Island and illustrates local line capacities with its HCA map. Xcel could do more to advance toward the ultimate goal: delivering its customers more cost-effective clean energy by integrating hosting capacity analysis with the interconnection process. Please contact our Customer Care Center if you have questions. These values are representative of the total amount of DG that is installed on the feeders and networks associated with the area substation. A potential applicant may submit a formal written request form along with a non-refundable fee for a pre-application report on a proposed project at a specific site. These network curves shows a representative load profile of the forecasted hourly peak (maximum) loads for 2018, and a representative load profile on light loads (minimum load) for the networks (based on 2017 data). What this does indicate is that a densely populated community like Oak Park would most likely have to get the majority of its solar and renewable electricity from outside its boundaries to reach the statewide RPS goal of 25%. ComEd's electric distribution system is dynamic and ComEd will provide periodic updates to the hosting capacity map. Granularity increases as users zoom in. Toll Free: 855-824-6131, The Electricity Forum Inc. (USA) Californias experience, says a policy paper, shows that best practice guidelines for validating maps are needed to aid state regulators. In summary, there are 5 things we ask of the Commission: Thank you for the opportunity to comment and for taking up this important conversation; we appreciate that there has not been any legislative preemption of this regulatory process. If you have any issues viewing the data, please Log in using your email address if you've already registered. This map does not restrict applications from being submitted for a particular circuit, but rather is a tool to inform applicants on the amount of generation a circuit has the potential to host without the need for significant system upgrades at the customer's cost. The Commission should host staff-facilitated working group sessions on integrating hosting capacity analysis with the interconnection process. Read our policy. Locational System Relief Value, or LSRV, is one component of the Value Stack that makes up compensation for Distributed Energy Resources (DER) under the Value of DER structure (pdf). The Electricity Forum (In Canada) If you have more to contribute, please comment with a link. The library zone below is used to load resources. Uninterruptible Power Supply (UPS) When was the last time you replaced your IT closets UPS? The Minnesota Public Utilities Commission has required that Xcel Energy, the largest electricity provider in Minnesota, conduct annual hosting capacity analysis reports since 2016.These reports identify where the grid can accommodate additional distributed generation capacity (including rooftop and community solar) and the results are displayed on the company's Hosting Capacity Map. However, if the Commission does not apply greater pressure for action, hosting capacity may continue to be a largely performative exercise without providing tangible benefits to Minnesota stakeholders and electric customers. The 8,760-hour forecasts are for informational purposes. Multiple states require electric utilities to share their power grid data with solar developers. Updates: Last updated in February/March 2017, with exception of Hosting Capacity map & supporting Portal documents. For example, the 18 sections of Oak Park Township capacity range from 612 to 909 kW, and total 13,260 kW of photovoltaic power. For the Stage 2 displays, each circuits hosting capacity is determined by evaluating the potential power system criteria violations as a result of large PV solar systems with an AC nameplate rating starting at and gradually increasing from 300 kW interconnecting to three phase distribution lines. Hosting Capacity is the amount of distributed energy that can be placed without requiring system upgrades or effecting power quality. The procedures for interconnection are divided into four levels as follows: Generally speaking, DG facilities that are certified by nationally recognized testing laboratories and meet certain standards of the Institute of Electrical and Electronics Engineers (IEEE), Underwriters' Laboratory, and the National Electrical Code, may qualify for interconnection under an expedited review process provided for in Levels 1 - 3. Xcel slows the adoption of cost-effective distributed generation. Xcel should be encouraged to update the hosting analyses monthly, or simply more regularly, he said. We continue to believe such an approach would risk grid security and customer privacy, confidentiality and security as described in more detail in Section III below and in attachment E. Therefore, we again provide a heat map view of available hosting capacity. You will not reproduce or use in any other medium, distribute, or otherwise use the tool or its information for any purpose other than the identification of potential sites for the interconnection of Distributed Energy Resources (DER) to ComEd's distribution circuits. The utility will also have to provide downloadable data of line segments with limitations they may have for adding capacity at different connection spots. That could potentially generate around 20 million kWh. Supporters agreed that the Companys participation in greater inter-developer transparency could facilitate cost-sharing in line upgrades and would be an improvement from the current cost-causer pays model. Although the values are meant to provide the user with a general idea of availability, space on the . Xcel has not fulfilled the requirements outlined in the Public Utility Commissions July 2020 Order. But the inefficient air conditioning units preventing your servers from overheating may be costing you more in energy costs and maintenance fees every month. Featured photo credit: Victoria Catterson via Flickr (CC BY 2.0). Solar hosting capacity maps, now required in seven states, show where solar can be added on a distribution circuit without incurring any grid expensebut only if those maps are accurate. The interactive map displays the highest circuit hosting capacity at the: Township, Section, Quarter-Section, Sixteenth-Section, and circuit level. Find a viable business owner interested in solar 2. L1W3V4 Your email address will not be published. Share to Facebook. SDG&Es HCA tool allows users to see hourly changes in load capacity., IRECs recommendations apply to both solar hosting capacity and load hosting capacity. Xcel has not fulfilled the requirements outlined in the Commissions July 2020 Order. Ameren Illinois has created a one-stop shop for Renewable Energy Developers to obtain all of the information they need to begin and complete a project. Additional information includes total solar already on the circuit, the circuits voltage, whether the circuit is three phase or single phase, and a range of substation bank information. But after the utility corrected its hosting capacity analysis, the map showed lots of green, the paper says, indicating lots of room for solarfor example for Monterey, California, shown at right, compared to lots of red in the initial version shown above. You may revoke this consent at any time with effect for the future, in which case your personal data will be deleted immediately. Please enable scripts and reload this page. ComEd anticipates that the Interconnection Queue data will typically be updated monthly. The risks could be mitigated somewhat by knowing the power grid well, or by tracking down an insider willing to answer specific questions. For example, Minnesotas community solar program is on track to reach one gigawatt of generation capacity as early as 2022 and ILSR predicts the development of an additional 475 megawatts of residential solar by 2034. Each quarter section is further subdivided into sixteenth-sections (1/4 mile X 1/4 mile). <> Please see Part 466 for specific qualification requirements (screens) for each interconnection level. The watchword is actionable. If the maps arent actionable (b/c theyre not accurate) they re actually worse than useless. Processing: Hosting Capacity map added on August 11, 2017. Examples include new loads, undergrounding projects, new circuits, voltage, and reliability. For these reasons, the installed and queued DG values in the data pop-ups have been included and will be updated on a monthly basis. We strongly recommend completing the application process online, as ComEd is making an effort to reduce paper use and streamline the application process. Error: Please call us at 1-800-752-6633 to complete this request. The Commission should, after considering stakeholder input in Docket No. As previously mentioned, existing DER is not considered in this stage of the hosting capacity analysis, and the data pop-ups are intended to provide additional context to the displays. To investigate whether PG&Es early solar hosting capacity results were accurate, California Public Utilities Commission staff worked with PG&E, IREC and other stakeholders. Only 3 URL's can be saved at a time. We thank the Commission for approving the November 2, 2020 Petition To Publish Certain Information about Applications in the Interconnection Queue, as we believe it will improve the interconnection process. Oak Park, according to the PlanItGreen Report Card, a joint project of the Oak Park River Forest Community Foundation and Seven Generations Ahead, uses about 325 million kWh.